Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
carts:nintendo:snes [2021/03/08 01:50] jonasrosland [Method 2 - Super NT / CopySNES] |
carts:nintendo:snes [2021/10/03 15:09] hiccup [Identifying Game Versions] |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| Some cartridges may also be not supported because of its memory mapping like Sufami Turbo and Satellaview compatible cartridges (like BS-X), or like game prototypes that don't contain proper info about the cartridge itself. | Some cartridges may also be not supported because of its memory mapping like Sufami Turbo and Satellaview compatible cartridges (like BS-X), or like game prototypes that don't contain proper info about the cartridge itself. | ||
| + | |||
| + | ===== Identifying Game Versions ===== | ||
| + | todo: add info on cart/box serials (and non-standard carts if relevant) | ||
| + | |||
| + | {{: | ||
| + | |||
| + | **SSS**(**S**)-**GG**(**GG**)-**V**\\ | ||
| + | S = System/ | ||
| + | G = Game code (e.g. MW = Super Mario World)\\ | ||
| + | V = Version (starts at 0)\\ | ||
| + | |||
| ===== Methods ===== | ===== Methods ===== | ||
| - | - Sanni Cart Reader | + | |
| - | - Super NT | + | - [[#Method 2 - Super NT / CopySNES|Super NT]] |
| - InfiniteNesLives Retro Programmer | - InfiniteNesLives Retro Programmer | ||
| - Retrode | - Retrode | ||
| - Super UFO Pro 8 | - Super UFO Pro 8 | ||
| + | - [[#Method 6 - RetroFreak|RetroFreak]] | ||
| - Copiers | - Copiers | ||
| + | |||
| ==== Method 1 - Sanni Cart Reader ==== | ==== Method 1 - Sanni Cart Reader ==== | ||
| Line 103: | Line 116: | ||
| The information above is retrieved from https:// | The information above is retrieved from https:// | ||
| + | |||
| + | ==== Method 6 - RetroFreak ==== | ||
| + | |||
| + | The RetroFreak is a great little emulation machine that uses physical carts similar to the Retron5. | ||
| + | |||
| + | Under standard conditions it is possible to let the RetroFreak copy the cart contents to an SD card, but they' | ||
| + | |||
| + | However, by using custom firmware and a few configurations to two files, you can get unencrypted dumps of your carts onto your SD card. | ||
| + | |||
| + | **WARNING 1** | ||
| + | |||
| + | Will this brick your system? Hopefully not. Proceed on your own risk. | ||
| + | |||
| + | **Get the binaries** | ||
| + | |||
| + | Start by downloading the release of [[https:// | ||
| + | |||
| + | Make sure you get the release that's _smaller_ than your SD card. If your SD card is 16GB you should get the 8GB release, etc. | ||
| + | |||
| + | **WARNING 2** | ||
| + | |||
| + | This will overwrite your SD card, so make sure you make backups of anything important before proceeding. | ||
| + | |||
| + | Unpack the retrofd zip file, and then use something like [[https:// | ||
| + | |||
| + | **Config** | ||
| + | |||
| + | There are two small file edits that you need to do. To make it simple, you can replace the existing files on your SD card with the ones attached. | ||
| + | |||
| + | Here are the changed files: | ||
| + | |||
| + | retrofd.cfg | ||
| + | |||
| + | <code -> | ||
| + | # clear micro SD partition 2/3 | ||
| + | RF_CLR_SDP23=no | ||
| + | # FACTORY TEST MODE | ||
| + | RF_FTM=no | ||
| + | # Log copy daemon | ||
| + | RF_LOGCD=yes | ||
| + | </ | ||
| + | |||
| + | rfd_logcd.sh | ||
| + | |||
| + | <code -> | ||
| + | # | ||
| + | |||
| + | while ! busybox grep "/ | ||
| + | do | ||
| + | busybox sleep 1 | ||
| + | done | ||
| + | |||
| + | # copy log files(/ | ||
| + | srcd=/ | ||
| + | dstd=/ | ||
| + | while : ; | ||
| + | do | ||
| + | busybox find $srcd -maxdepth 1 -type f | busybox sed -e ' | ||
| + | do | ||
| + | [ -f " | ||
| + | done | ||
| + | busybox sleep 1 | ||
| + | done | ||
| + | </ | ||
| + | |||
| + | **Usage** | ||
| + | |||
| + | Boot up the RetroFreak with the new SD card inserted, you should be able to use and play your carts like normal. Once you insert a cart, let RetroFreak install it to the SD card. Now start the game for a few seconds. | ||
| + | |||
| + | After you've started a game, the unencrypted dump will be copied onto your SD card under `/ | ||
| + | |||
| + | Once you've turned off the RetroFreak, you can take out the SD card and look the contents and verify your unencrypted dumps. | ||
| + | |||
| + | They should have names such as `homebrewgame-decrypted.NES` and `awesomehomebrew-decrypted.SFC`. | ||
| + | |||
| + | //Needs verification// | ||
| Line 147: | Line 236: | ||
| ===== Submitting Dump Info ===== | ===== Submitting Dump Info ===== | ||
| - | You can submit your dump info to the [[https:// | + | {{wst> |
| < | < | ||