Differences

This shows you the differences between two versions of the page.

--- carts:sega:mega-drive-genesis [2023/02/19 23:09] – cartridge_hermit
+++ carts:sega:mega-drive-genesis [2025/10/18 18:00] (current) – hiccup
@@ Line 3: / Line 3: @@
 {{wst>vgpc_help}}
+**Warning:**
+{{wst>unlicensed_cart_warning}}
 ===== Introduction =====
 There are numerous dumping tools available for the Sega Mega Drive / Genesis games, several for sale and many, many more open source electronics projects.
+x games can be dumped like normal carts, but for Sega CD games you can use the [[discs:general|general disc dumping guide]].
 The cheapest option is a RetroBlaster, followed by the Retrode2.
@@ Line 16: / Line 20: @@
   - [[#RetroBlaster 2.0 + Genesis Adapter]]
   - [[#Retrode2]]
-  - [[#Sanni Cart Reader]]
+  - [[#Open Source Cartridge Reader]]
   - [[#RetroFreak]]
@@ Line 35: / Line 39: @@
 Open the RetroBlaster software (click Run if you see a security warning about the publisher not being verified) and navigate to the Genesis tab.
+{{:carts:sega:retroblaster_software_genesis.png|}}
 Click "Dump ROM." Choose the location and filename for your ROM.
@@ Line 51: / Line 57: @@
   - The Retrode2 should now show up as a regular USB drive, and you can copy the ROM from there for further analysis.
-==== Sanni Cart Reader ====
+==== Open Source Cartridge Reader ====
-The Sanni Cart Reader comes with Mega Drive / Genesis dumping capabilities by default.
+The Open Source Cartridge Reader (OSCR) comes with Mega Drive / Genesis dumping capabilities by default.
-Visit the [[https://github.com/sanni/cartreader/wiki/Reading-Mega-Drive-Genesis-games|Sanni Cart Reader wiki]] for proper settings, and dumping instructions.
+Visit the [[https://github.com/sanni/cartreader/wiki/Reading-Mega-Drive-Genesis-games|OSCR wiki]] for proper settings, and dumping instructions.
 ==== RetroFreak ====
@@ Line 61: / Line 67: @@
-==== Opening carts ====
+===== Opening carts =====
 Most games use 4.5mm Gamebit screws, but less commonly use T3 (1.20mm) security torx or (rarely) tri-groove screws. After removing the screws, lift the back off and remove the PCB from the two pegs.